ddrum DDTi, Reference Manual

Page: 27 / 34

23
TROUBLESHOOTING
SYMPTOM CAUSE SOLUTION
The display does not light
up.
No power.
If you are using USB power, check that the
power switch on the back of the DDTi is in the
OUT (USB) position. If you are using an AC
adapter, check that the adapter is plugged
into a live power outlet and that the power
switch is in the IN (AC) position.
MIDI:
No sound from target
device.
DDTi USB not properly
connected.
Check
your computer’s USB connections to
confirm that the DDTi is recognized and
installed. Turn you computer off and then on
again if necessary.
(Choose “shut down”
rather than “restart” to ensure that the USB
devices are properly reset.)
Problems caused by use of a
USB hub.
Try unplugging the DDTi from any USB hubs
and connecting directly to the computer.
Software application not set up to
receive MIDI data from DDTi
controller.
Ensure that the DDTi
or “USB” MIDI device is
listed as an active MIDI source in your
application.
Software application not receiving
MIDI data.
Many software applications have MIDI IN and
OUT indicators. Play the triggers and look for
the MIDI IN light to indicate activity.
DDTi’s MIDI channel not the
same as target device
’s incoming
MIDI channel.
Be sure that the DDTi is sending on the
channel that the target device expects.
DDTi 5-pin MIDI OUT not
connected to target device
’s MIDI
IN.
Ensure that any 5-pin cables are connected to
the proper inputs and outputs.
My footswitch behaves in
an opposite manner.
Footswitch was plugged in after
power was turned on.
If using a footswitch with the INC/DEC input,
turn the unit’s power off, wait a moment, and
then turn it on again. Please always make
sure that footswitches and triggers are
connected to the DDTi prior to powering on
the unit.
For other footswitches, go to Trigger Type
and reselect the type with the footswitch in the
UP position.
My pad is triggering even
when no pads are hit.
The pad’s Gain setting is set too
high or the Threshold is too low.
Lower the pad’s Gain setting or raise the
Threshold setting.