- 13 -
Control
Description
Parameter Setting Buttons
Serve to display current device settings:
Spot Size (mm); Pulse Duration (pulse width, ms);
Frequency (Hz)-pulse repetition frequency. Parameter
(except for the Spot Size) can be edited by either using
increase/decrease arrow buttons (incremental change) or by
sliding the gray bar left or right. Current value of each laser
setting is displayed in the center of the corresponding
horizontal window. The Spot Size can be selected by
pressing correspondent round Spot Size button.
Fluence Button
Serves to set Fluence on the target. After user presets
desired fluence level, the system parameters are adjusted
based on the laser calibration table (stored in system
memory) and current Pulse Duration and Beam Size
settings. Fluence is a measure of energy density and is
shown as Joules/cm
2
. Fluence can be changed the same
way as other parameters (see above).
Memory Selection Buttons
Serve to recall pre-set Operating Parameters stored for each
combination of Skin Type, Hair Type, Hair Color and
Body Area. The recalled pre-set treatment parameters can
be still adjusted with Parameter Setting Buttons, as
described above.
Save/Ready Button
Serves to switch between EDIT and READY system modes
while saving new parameter settings for the current
treatment session.
Vein Button
Serves to switch between HAIR and VEIN treatment
modes.
Switch to YAG Button
Used to switch between Alexandrite and Nd:YAG
operation modes.
Memory Set Button
Used to enter pre-set Operating Parameters Edit Screen,
where user can override factory memory settings for
preferred treatment parameters and customize it based on
his/her desire and experience.
Service Button
Used to switch between EDIT and SERVICE screens
Sound ON/OFF Button
Used to turn the pulse beep sound ON or OFF
