10
USING YOUR BEER DISPENSER
Tap Equipment and Assembly
Your dispensing kit includes the following parts:
Polished stainless steel tower with clear beer line (single
or double dispense)
Tower Gasket
Phillips oval head screws
Knob for Tower (Faucet Handle)
Keg coupler(s)
CO
2
regulator with red gas line(s) attached
Empty 5 pound CO
2
tank
Plastic clamp(s) large and small
Faucet wrench
Tools required for installation:
Flat bladed screwdriver
Phillips screwdriver
Pliers
Adjustable wrench or a 1
1
⁄
8
" open end wrench
1
⁄
2
" open end wrench
Barrel Sizes
1/6 barrel
1/4 Barrel
1/2 Barrel
Height
23
5
⁄
16
"
(59.2 cm)
14
13
⁄
16
"
(37.6 cm)
23
5
⁄
16
"
(59.2 cm)
Diameter
9
1
⁄
4
"
(23.5 cm)
17"
(43.2 cm)
17" to 17
1
⁄
4
"
(43.2 to 43 cm)
Gallons
5.16
7.75
15.5
#12 ounce
Glasses
60
82
163
This beer dispensing unit will support
1
⁄
2
barrel or
1
⁄
4
bar-
rel. The double draft tower units can support two sixth (
1
⁄
6
)
barrels of beer. See chart below for quantity of beer in each
barrel size.
Table A
Table B
Keg Size
#of kegs per
5 pound CO
2
Tank
5 gallon Corny
15 to 22
1/6 barrel
14 to 21
1/4 Barrel
10 to 14
1/2 Barrel
5 to 7
CO
2
can be dangerous. If it becomes difficult to
breathe and/or your head starts to ache, a high
concentration of carbon dioxide may be present.
Leave the area immediately.
• The CO
2
tank must always be connected to the
regulator.
Never
connect the tank to the keg.
• The CO
2
tank must be securely mounted in the
upright position. Secure it with the chain pro-
vided.
• Never
drop or throw the CO
2
tank.
• Keep the CO
2
tank away from heat.
• Ventilate the area after a CO
2
leak.
!
WARNING
1. Remove shelving and packaged components from the
interior of the refrigerator before beginning the assem-
bly process.
2. Take your empty 5 pound CO
2
tank to your local gas
supply dealer to be filled. You can usually find them in
your "yellow pages" under "Welding Supply" or "Fire
Protection". One 5 pound tank can process many kegs
(see table "B") Your dealer should supply you with a
new plastic washer every time the tank is filled. This
washer is used at the regulator to tank connection. See
Figure 15 and 22 on page 11. Replace the old washer
with the new one whenever the tank is refilled.
3. Tower mounting (if you are installing the unit under a
counter skip to step 4). If you are mounting the tower
directly to the top of the refrigerator, first remove the
four screws from the top of the refrigerator. Feed the
clear beer line through the tower gasket and the large
hole in the refrigerator top. Align the 4 holes in the
tower with the 4 holes in the refrigerator top and secure
the tower with the 4 screws removed previously. Skip to
step 5.
