9
USING YOUR ELECTRONIC CONTROL
Starting your beer dispenser
Plug the beer dispenser power cord into a wall outlet. Your
beer dispenser will begin cooling after power is applied.
If your beer dispenser does not start, check that the beer
dispenser is turned on and the set temperature is cold
enough.
Turning your beer dispenser ON or OFF
If the beer dispenser is on, the beer dispenser temperature
will be shown on the display. To turn the beer dispenser
off, press and hold the "ON/OFF" button for three seconds.
"OFF" will appear on the display.
If the beer dispenser is not on, "OFF" will be shown on the
display. To turn the beer dispenser on, press and hold the
"ON/OFF" button for three seconds. The beer dispenser
temperature will be shown on the display.
Set temperature
To set the beer dispenser temperature, press and hold
the "SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.
Beer dispenser operation
The available temperature range of the beer dispenser is
34 to 46°F (1 to 8°C).
It may take up to 24 hours for your beer dispenser to reach
desired temperature. This will depend on amount of content
loaded and number of door opening and closings.
For best results allow beer dispenser to "pull down" to
desired set temperature before loading. Once contents are
loaded, allow at least 48 hours for temperature to stabilize
before making any adjustments to the set temperature.
•
Temperature Sensor Fault:
If the control-
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one second intervals. "E1" will
flash on the display panel and the Alarm LED located at
the top left of the display below the word "Alarm" will be
illuminated.
Alarm Mute
Press any key to mute the audible portion of an alarm.
NOTE-This action will only mute the alarm. If the condi-
tion that caused the alarm continues, the alarm code will
continue to flash and will sound for 20 seconds every 60
minutes.
Set
Colder
Warmer
ON/OFF
Press and Hold
Press and Hold
Alarm
F
Figure 10
close-up of
control
Alarms
Your digital display function will monitor beer dispenser
function and alert you with a series of audible and visual
alarms.
•
Door Ajar Alarm:
If the door has been left
open for over five minutes, the alarm
will sound in one second intervals. The
display panel will flash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. This will stop as soon as the door is closed.
Figure 11
