D
IGITAL
C
ONTROL
I
NCORPORATED
DigiTrak MFCB Operator’s Manual
3
Interference at the remote display may also occur from other sources operating nearby
on the same frequency, such as car rental agencies using their remote check-in modules
or other directional drilling locating equipment.
Background noise must be minimal and signal strength must be at least 150 points above
the background noise during all locating operations.
Because this equipment may generate, use, and radiate radio frequency energy, there is
no guarantee that interference will not occur at a particular location. If this equipment
does interfere with radio or television reception, which can be determined by powering
the equipment off and on, try to correct the interference using one or more of the
following measures:
o
Reorient or relocate the receiving antenna.
o
Increase the separation between the receiver and affected equipment.
o
Consult the dealer, DCI, or an experienced radio/TV technician for help.
o
Connect the DCI equipment to an outlet on a different circuit.
Caring for Your Cable Box
Do not disassemble. The cable box contains no user-serviceable parts.
Clean exterior with a damp cloth.
Do not submerge.
Do not pressure-wash.
Ensure all ports remain clean and clear of debris by keeping protective caps on power ports
and power post when not in use. Use compressed air or a soft brush to remove debris from
the power ports. Use a wire brush to clean the power post.
Send in the Product Registration Card for the 1-year limited warranty.
Caring for Your Transmitter
If the cable wire becomes exposed at the base of the transmitter, the cable should be
trimmed and reinstalled or replaced. Parts for repairing or replacing the cable are provided in
the repair kit included with the system. See
Appendix B: Transmitter Wire Repair or
on page 14.
Keep the SST transmitter at least 5 ft. (1.5 m) away from all magnets, including the remote
display and cable box, which have magnetic mounts that will damage the transmitter. A
protective magnetic shield is provided with the SST transmitter and also available through
any authorized DigiTrak dealer. Place the magnetic shield on the end of the SST transmitter
whenever the transmitter is not in use.
Send in the Product Registration Card for the 90-day limited warranty.
