99
SERIES 5 SIDE DELIVERY SYSTEM
Instructions For Use
OPERATION - SELF-CONTAINED WATER SYSTEM
USING BOTTLED WATER
REFILLING THE BOTTLE
SELF-CONTAINED WATER SYSTEM
The self-contained water system allows you to isolate your practice
from the municipal water supply. The self-contained water system
uses a pressurized bottle to supply water to the dental unit, giving you
full control of the source and quality of the water. A selector valve
allows you to select either the city water supply or a bottled water
supply of your own choice.
USING WATER BOTTLE
1. Ensure that the Water Bottle On/Off switch is turned OFF.
Fill the water bottle to just below the neck, then install to
the manifold. Turn the Water Bottle On/Off switch to the
ON position and check for leakage at the bottle. If air or
water leakage is observed, turn the Water Bottle On/Off
switch OFF to release all pressure before tightening the
bottle to stop leakage.
2. Select either city water or bottled water supply source, as
desired, using the City/Bottle Selector on the dental unit.
1. Turn the Water Bottle On/Off switch to the OFF position
and allow several seconds for air pressure to be released
from the bottle.
Never attempt to unscrew the bottle
while it is pressurized!
2. After relieving pressure, remove the empty bottle and install
a full bottle.
3. Turn the Water Bottle On/Off to the ON position and check
for leakage at the bottle as previously described.
CAUTION:
Only use water bottles supplied by the manufacturer. Do not use soft drink bottles
which are thin walled and may rupture when under pressure.
WARNING:
Do not attempt to adjust the water bottle pressure. Bottle pressure is factory pre-set
at 40 psi. Pressurizing the water bottle over 40 psi may cause the bottle to rupture.
CITY / BOTTLE SELECTOR
WATER BOTTLE
ON/OFF TOGGLE
