(The Client Password is entered in the
Server Mode Settings
portion of the page when XT-3305
A is configured as a Server: The values in the
Client Mode Settings
fields are ignored in this
case.)
Figure 5 – Ethernet Tunnel Settings for XT-3305 “A”
To make these changes active on XT-3305 A, click the
Store&Activate
button near the bottom
of the screen. Wait a few seconds to make sure the changes have been applied.
8:
Open the second box and apply power to the XT (XT-3305 “B”) to be configured as the Client
unit.
If there is a second PC (PC “B”) available, use it to configure this unit. If only one PC is
available, then
before plugging the ethernet cable into this second unit
, reboot the PC
or open a Command Window (as Administrator) and type the command
arp -d
192.168.0.1
, which should clear the ARP Cache and guarantee that there will not be an
address conflict.
9:
Repeat steps 4 and 5 to access the Quick Startup screen.
10:
Configure the IP addresses for LAN1 (trusted) and LAN2 (untrusted) and click
Static-
Configuration
for LAN2 as shown in Figure 6 below.
All other parameters can stay at the
default values.
Figure 6 – LAN Settings for XT-3305 “B”
3
