Connect the Power
:
Make sure that the CM-1 will be receiving 120 VAC @ 5 amps of clean dedicated power.
Do not connect the CM-1 to power lines that share AC Motors, Heaters, or Inductive
loads. This will cause sporadic data transmission and undesirable results in correct data
transmission and reception.
-
Use the provided
24VDC at 1 Amp
wall transformer to power the CM-1.
Note: The use of any other wall transformer other than what is required by DC-
Digital will void warranty.
Observe:
-
The RED 5 volt LED will light. See Picture…..
-
The Data RED LED will flash every time the EZ-time Software sends data out of
the designated computer COM Port either manually or automatically. See Picture
for location of the RED Data LED.
NOTE: The GREEN LED must stay on steady and RED LED must flash to indicate
correct CM-1 operation.
