Put 2 pieces new battery of 1.5V AAA inside the computer correctly
,
and ride the bike several circles
within 2 minutes (for the sensor already installed battery). Make the wireless sensor receive the signal
from the magnet moving. Or replace the battery of the sensor within 2 minutes
,
and then the
computer will finish the code matching with the sensor automatically. Once finished the code
matching, the computer will display the measured data automatically
Remarks:
①
Make sure the sensor will receive the signal from the magnet
②
After the battery replacement of the computer
,
if not receiving the sensor 's signal or the sensor
did not replace battery within 2 minutes
,
the computer will save the coded data of last time
automatically
③
Only one set of products can operate the code matching at the same time
④
The distance between the computer and the sensor should be no more than 2M
⑤
After the code match operation
，
if the computer still can not display the measured data
,
please
check the sensor 's battery is installed properly or not
，
or the whether the battery voltage is over
2.6V
,
or the place between magnet and sensor is correctly or not
，
or whether there's several sets
of product s are operating the code matching. After the above confirmation
,
operate the code
matching again
2.RESET
In any displays, hold MODE button for 2 second s to reset all the data
3.
SET THE TARGET PARAMETERS
When stop exercise (icon 0 not display)
，
press MODE to choose the window to be set or reset
，
the
corresponding window displays SET
，
meanwhile
，
the window's digit flash
，
press RESET to clear the
value
，
and press SET to set the flashing window's value. Hold the button to quick increase
Set the value as:
TIME→DIST→CAL.
4.
CHECK THE EXERCISE DATA
①
In non- set mode
，
press SET or during exercise
，
icon 0 displays
，
press MODE to separately
check the SPEED / AVG. SPEED /MAX SPEED
，
CALORlES/ RPM
，
PULSE/AVG. PULSE/ MAX PULSE .
②
When icon 0 displays
，
it
means the computer is scanning the display. lt will scan the display the
value in corresponding window every 6 seconds
5. PULSE RECOVERY
Wear the transmitter belt properly
,
or hold the hand pulse place
，
the computer will display your
current heart rate
When the pulse window has the display
,
stop exercise
，
press RECOVERY to enter the function of
pulse recovery. The display will show 1 minute countdown as well as your pulse rate
,
test your pulse
until it counts down to zero. Then it will pop up your pulse recovery level from F1 to F6
，
that is
,
from
the fastest recovery to the slowest. The fastest recovery F 1 shows the best
,
F6 mean s the slowest.
Press RECOVERY again to exit the pulse recovery function.
