Http://www.dbltek.com VoIP FXS+PSTN Gateway
10
bridge mode.)
*11983185922#
Reset all system parameters back to factory
defaults.
Please see section 2.1 for hardware reset
option.
Note: These commands are factory preset and cannot be modified.
3.1.2 Commands for Phone Operation
The available commands for phone operation are 3-digit long at least and some
contains operands. These commands are shown in the table below and they can be
programmed to other values via the built-in Web Server.
Command
Function
*12
Switch to VOIP line
*21
Switch to PSTN line
*42
Hold the current call / Release the Hold call
*41
Call Transfer to another VoIP Number
*50
Phone book function key
3.2 Set up
The device supports two major configuration methods.
1. Provisioning Server
The device can be programmed at the factory, via a DHCP Host, or via the built-in
web server to execute an Auto Provisioning Procedure to obtain a configuration file
from a Provisioning Server (a HTTP or a TFTP server). This configuration file
contains all the necessary parameters to set up the device for VoIP Services. This
method requires no manual operation once the Auto Provision mode is set and
greatly simplifies the installation and configuration of the device. This is a
proprietary method. Please your local support for more information.
2. HTTP Web Server
The device comes with a built-in HTTP Web Server for user configuration. A PC on
the same network segment can access the built-in Web Server by entering the IP
address in a Web Browser. Please refer to Section 4 for more detailed information.
