GoIP User Manual
http://www.dbltek.com
10
3.2 Status
There are four pages under the Status category and they are Summary, General, GSM, and SIM Call Forward.
Each page is refreshed every 5 seconds; however, this feature is not supported when the Firefox browser is
used.
Sample pages shown in this section are captured from a GoIP-8.
Please refer to the actual web
pages of the models of interest.
It is important to understand the information shown in these pages in order
to debug or report problems encountered.
3.2.1Summary
The current VoIP and GSM statuses are listed in the Summary page as shown below (extracted from GoIP-8) .
They are very essential to display the operation status of the GoIP in order to determine if it is working
properly or not.
Here are the list of GoIP parameters shown in this page.
1. CH - GoIP channel reference
2. M - GSM module status for the corresponding CH.
"Y " means "Enabled" and "N" means "Disabled".
If a
GSM module is disabled, all other parameters for this channel are not active.
Clicking "Y" shuts down
the channel selected.
Clicking "N" turns on the channel selected.
3. SIM - SIM card status.
"Y" means that the corresponding GSM module can access the designated SIM card
successfully.
"N" means unable to access the designated SIM card.
Please check if the SIM card is
inserted properly or the SIM card is damaged.
If Remote SIM function is used, please check the SIM
Bank and/or SIM Server configuration.
The problem could also be caused by bad network condition or
improper network configuration.
4. GSM - GSM registration status. "Y " means "Registered" and "N" means "Not Registered".
5. VoIP - VoIP registration status.
"Y " means "Registered" and "N" means "Not Registered".
If GSM
Registration status is "N", VoIP registration is disabled and its status should be ignored.
6. Status - VoIP line status.
If VoIP registration status is "N", the VoIP line status shown should be ignored.
Once VoIP registration status is "Y", the current VoIP line status is then shown in this field.
Here are a
list of available statuses:
a. IDLE - The VoIP line is not engaged in any call activities.
b. CONNECTED - An active call between VoIP and GSM is in progress.
c.
ACTIVE - A second dial tone is generated when a VoIP call is answered without making a GSM call or
when a GSM call is answered without making a VoIP call.
The generation of a second dial tone
prompts the caller to press a phone number.
The "Status" changes to "ACTIVE" since the start of
the second dial tone till
a phone number is received for dialing or the call is terminated.
