DVB-T/T2 terrestrial receiver
MERlin
Using the Web Page
2013 dB Broadcast Ltd
18
Version 1.2
Serial Number
Read only.
Software Version
Read Only.
FPGA Version
Read only.
Use DHCP
It is recommended to leave this box unchecked and enter a fixed IP address.
MAC Address
Read Only
Set/Confirm IP Address
Use these boxes to enter a new IP address. Greyed out if DHCP used.
Subnet Mask
Enter a subnet mask; usually 255.255.255.0. Greyed out if DHCP used.
Default Gateway
Only used in large network configurations. Greyed out if DHCP used.
SNMP Trap Destination 1 and 2
If SNMP is in use check one or more SNMP boxes and enter the applicable SNMP
destination(s).
Set the Public and Private Community Names
SNMP Community Read “Public”
SNMP Community Write “Private”
Station Identity
A user entered fifteen character alphanumeric. When the MERlin is interrogated remotely, the
station ident is reported over the SNMP MIB. This enables operators to check that they are
looking at the required receiver.
Save All Changes
When done click on
Save All Changes
.
If the DVB mode is changed, the message Changing the DVBMode may cause loss of picture.
Do you wish to continue? Click on Yes to continue.
Changes made when leaving the Device Configuration tab without saving will be lost.
Tabs not related to the chosen DVB mode will be greyed out. If they are already open when a
mode change occurs, those tabs will be replaced by the summary tab for the deactivated mode
when clicked on.
