4.1. Use with d&b Touring rack I/O panel
4 channels per rack
(Z5563 DS10 Rack upgrade kit)
It is not necessary to re-cable the touring rack(s).
1. The DS10 is mounted above the I/O panel.
For this purpose, simply dismantle the rack drawer.
2. Connect the two digital outputs at the front of the DS10 to the
digital inputs D1/2 and D3/4 of the I/O panel.
3. Connect the ETH 3 port of the DS10 to the ETH 1 port of the
I/O panel in order to bridge the R1 control for the amplifiers
over the Dante network.
Note: Connect only one of the Ethernet ports on the I/O
panel to the DS10. Otherwise an Ethernet ring is built, causing
a packet storm
Þ
Network no longer accessible.
4. On the rear, connect the power cord
[2] (powerCON/
powerCON) to the auxiliary powerCON socket of the mains
distributor.
12 channels per rack
(Z5339 Multichannel Extension Cable)
For this purpose, the d&b Z5339 Multichannel Extension Cable is
available (to be ordered separately).
If more than four channels per rack are required, the digital output
connectors at the rear can be used to feed the lower two amplifiers
in the rack separately, for a total of 12 different channels from the
Dante network.
d&b Z5339 Multichannel Extension Cable
4. Rack connections
d&b DS10 Manual 1.5 en
14
