5
4. Setting up the device
Adjusting the brightness
brt
:
With this parameter the brightness of the display can be reduced onto 25% of the total
brilliancy. With
[P]
the selection is confirmed and the device switches back into menu
level.
Setting the decimal point,
dot
:
The decimal point on the display can be moved with [
▲
] [
▼
] and confirmed with
[P]
.
The display then switches back to the menu level again.
Selection of the device address
Adr
:
Device addresses from 1-125 can be parametrised. The address 126 is preset as
default value, which is the delivery state. After changing this parameter, the device
does a soft test bevor switching back into operation mode. After this, the new address
will be directly in use.
Parameterisation level
Menu level
4.1. Switching-on
Once the installation is complete, you can start the device by applying the voltage supply.
Before, check once again that all electrical connections are correct.
Starting sequence
For 1 second during the switching-on process, the segment test (
8 8 8 8 8
) is displayed
followed by an indication of the software type and, after that, also for 1 second the software
version. After the starting sequence, the device switches to operation/display mode.
4.2. Standard parameterisation:
(Flat operation level)
To parameterize the display, press the
[P]
key in operating mode for 1 second. The display
then changes to the menu level with the first menu item
TYPE
.
4. Setting up the device
