4 3
Trouble shooting Tips
Maintenance and Service
Problem
Action
Remote controller does not work.
1. Check if main power is On.
2. Check that the batteries of the remote controller were
loaded properly.
3. Check to see if any obstacle exists between the PDP
TV and the remote controller and remove it, if any.
4. If the batteries have no power, replace them with two
new batteries.
PDP TV makes strange noise.
It is the noise when the mechanism expands or contracts
from to changes to the environment due to factors such
as humidity, temperature, etc. It is not a failure.
PDP TV indication lamp is On.
The red means the Stand-by power is ON. It will take a
few seconds to turn off as the main power is off.
Had forgotten Password of V-Chip
Can not select PC mode when D-sub
D-sub cable must not meet VESA standard. (D-sub No. 10
cable is connected to the RGB output
pin must be grounded) Component Cable can be used if
of Set-top-box.
there is an Component Terminal.(See Page 18)
This PDP TV is for household use and registered as suitable on electromagnetic waves.
Therefore, you can use it in every location as well as residential areas.
●
Others
If any signal of unsupported resolution is input, the "Out of Range" message appears.
●
Considerations in Installation
It is optimal screen when the resolution is 640 x 480.
Resolution
Horizontal Frequency (KHz) Vertical Frequency (Hz)
31.47
60
37.86
72
37.50
75
31.47
70
35.15
56
37.88
60
48.08
72
46.88
75
48.36
60
56.48
70
60.02
75
640
×
480
720
×
400
800
×
600
1024
×
768
●
Supporting display mode
Press
,
,
,
,
buttons on the Remote
control in V-Chip function.
Summary of Contents for PLASMA DISPLAY
Page 45: ...Memo Maintenance and Service ...
Page 46: ...42 PDP TV User s Guide ...
