DAYGAS LODOS Series, User Manual

Page: 19 / 28

Lodos Series
Safety Precautions While Using
» When using heaters, the requirements of technical regulations, construction,
plumbing, fire regulations and standards must be met.
»
The heater must be grounded. The heater is not allowed to be turned on without
grounding.
»
It is not allowed to operate the device with damaged ceramic tiles.
» The heater should be mounted on non-combustible structures.
» If there is a gas smell in the room, it is forbidden to open the device.
»
The place where the heater works must be equipped with fire extinguishing equip-
ment in accordance with fire safety requirements.
»
When used outdoors, the heater should be protected from precipitation and wind.
» While the heater is running and within a few minutes after it is turned off (the
heated parts until completely cooled) to the boiler, burner, reflector, device case
touching is prohibited.
Gas and Electricity Connetion
Considerations
Gas Connection
The gas connection of the device has been authorized by the distribution
company and must be done by certified persons.
The gas line must have a pressure of 20 - 50 mbar. Gas pressure must be
checked before connection.
Electrical Connection
After the device is installed, make sure to measure your electrical line before
energizing the device.
Before energizing the device, make sure that the grounding line is in your
power line make sure it is. Never give electricity to the device without a
grounding line.
The electrical connection of the device is in the form of a C-14 socket. Do not
make the connection with any cable other than the power cable that comes
out of the device and do not cut the existing power cable.
Before giving electrical energy to the device, make sure to measure your
electrical line. Our device works with 220/230 V 50 Hz. These values change
in case of interference, make sure to stabilize your line with regulatory
devices.
19
www.daygas.eu