Seat Angle and Depth
.
Newer Day 6’s have two bolts
at the top of the seat post. Loosen them. (If the Horizontal
Backrest Tube is attached to the seat post, you will first need
to move it out of the way by loosening the two bolts that
attach it to the seat post.)
Seat post 1” back
from
bend
Contour Seat attaches
to mounting base with
four 1/4-20 bolts
Place seat post about 1” from the seat
pan bend (see above) and allow seat
post to tilt back as far as it will go.
Tighten the two seat post bolts
securely, going back and forth
between them until they are tight. This
will put the bottom of the seat parallel to the ground
which is correct for most people. If not, loosen bolts
and readjust angle. Securely tighten the bolts after
finding the correct seat position and then reinstall the
Horizontal Backrest Tube.
NOTE: It is CRITICAL that the 2 seat post bolts are
tight at ALL times. Check your seat before each
ride. Failure to do this can cause serious injury.
Horizontal Backrest Tube
Proper seat angle
Page 4