Dawson EMV-220 METRIC, Operator'S Instructions/Spare Parts List

Page: 21 / 51

movement will allow the assembly to rattle around, make more noise and
cause in turn more wear. If the axial play exceeds 1mm it will be necessary to
tighten the nut. To do this remove the coil/spring pin with a punch and hammer,
tighten the nut further and drill and pin it in the new position.
i. Check the condition of the boom Adaptor Bracket, Shear Pins, Spacers and
Bushes. The whole assembly should be relatively tight with minimal play in the
FRPSRQHQWV7KHEUDFNHWQHHGVWREHDEOHWRÀRDWDOLWWOHIURPVLGHWRVLGH±DV
much as 5/10 mm is acceptable. The pins and bushes should however be little
PRUHWKDQDUXQQLQJ¿W±FOHDUDQFHVRIPRUHWKDQPPZRXOGEHFRQVLGHUHG
excessive.
Swivel Assembly
Breather /
Filler Plug
Clamp Cylinder
Clamp body Grease
Point - for Moving Jaw
Hard Jaws
Lifting Chain &
Chain Clamp
Gearbox Oil
Drain Plug
Front View
Base View