Dawlance GLAMOUR INVERTER 45 FS, Instruction Manual, Page: 23 / 32

INSTALLATION MANUAL---Installation of the Indoor unit
The piping can be run in the 3 directions indicated by
numbers in the picture .
Run the piping in the direction of the wall hole and bind
the copper pipes , the drain pipe and the power cables
together with the tape with the drain pipe at the bottom,
so that water can flow freely.
torque wrench
21
Refrigerant piping connection
1. Remove the indoor unit pipe cap (check that there is
no debris inside).
2. Insert the fare nut and create a flange at the extreme
end of the connection pipe.
3. Tighten the connections by using two wrenches
working in opposite directions
Connections to the indoor unit
Shape the connection pipe
for connecting pipes
and drain pipe
Hole for cables
(both on left and right sides)
Gas pipe
Liquid pipe
For connecting pipes,
drain pipe and cables
A. Backward direction
B. Left or right direction
drain pipe
Select a most suitable one
for installation convenience.
Do not remove the cap from the pipe until connecting
it, to avoid dampness or dirt from entering.
If the pipe is bent or pulled too often , it will become
stiff . Do not bend the pipe more than three times at
one point.
When extending the rolled pipe, straighten the pipe by
unwinding it gently as shown in the picture.
NO
YES
Extending the rolled pipe
Friendly reminder:
In order to facilitate the installation, the thicker connecting
pipe of this model (when the indoor side is connected to
the rear) needs to have
375mm thread L. Otherwise,
the connecting pipe may bear against the filter net, and
there is a problem that the filter is loose or the gap of
the lower panel is too large;
Friendly reminder:
In order to better protect the connecting pipe and the
connecting line, the pipe hole sealing component needs
to be installed on the pipe hole. The specific installation
position is determined according to the actual pipe running
direction (left side plate, right side plate, rear plate); after
the connecting pipe is installed Fix it with 1 screw, and
the specific position can be moved according to the actual
situation;