● The connection method of the air conditioner and the power cord
and the interconnection method of each independent element
shall be subject to the wiring diagram affixed to the machine.
● The model and rating value of the fuse shall be subject to the
silkscreen on corresponding controller or fuse sleeve.
Others
PC
Drain pipe
1
5
Plastic Strap
Pipe Protection Ring
Luting (putty)
NOTE: All accessories shall be subject to actual packaging material, and if there
is any difference, please understand.
Packing list of the indoor unit
Packing list of the outdoor unit
No.
Name
1
2
3
1
Indoor Unit
Set
Quantity
2
Remote Controller
Batteries
(
7#
)
PC
PC
1
Instructions
4
Outdoor Unit
Connecting pipe
Packing list
1
Notices for installation
5
No.
Name
1
2
3
ROLL
4
Unit
PC
1
1
1
Set
Quantity
PC
1
2
Unit
PACKET
Set
1. Make a hole with an electric hammer or a
water drill at the predetermined position on
the wall for piping, which shall slant outwardly
by 5°-10°.
2. To protect the piping and the cables from
being damaged running through the wall,
and from the rodents that may inhabit in
the hollow wall, a pipe protecting ring shall
be installed and sealed with putty.
1. The wall for installation of the indoor unit shall
be hard and firm, so as to prevent vibration.
2. Use the "+" type screw to fasten the peg board;
horizontally mount the peg board on the wall, and
ensure the lateral horizontal and longitudinal vertical.
3. Pull the peg board by hand after the installation,
to confirm whether it is solid.
Space to the ceiling
Space to the wall
20cm right
Mounting plate
Wall-through Hole
15cm below
200cm above
Space to the floor
Pipe protection ring
Putty
Dimension drawing of indoor unit installation
Space to the wall
20cm left
Note: Usually, the wall hole is Φ60mm~Φ80mm.
Avoid pre-buried power wire and hard wall
when making the hole.
Install indoor unit
15
14
Summary of Contents for Classic Plus 15
Page 13: ......
