INDOOR UNIT INSTALLATION
Before maintenance
Do not use a chemically treated cloth or duster to
clean the unit.
Do not use benzine, thinner, polishing powder, or
similar solvents for cleaning. These may cause
the plastic surface to crack or deform.
O
O
Never use water hotter than 40 C/104 F to clean
the front panel, it could cause deformation or
discoloration.
CAUTIONS
Care and Maintenance
Turn the system off before cleaning. To clean, wipe with
a soft, dry cloth. Do not use bleach or abrasives.
NOTE: Power supply must be disconnected before
attempting to clean or service!
Cleaning the unit
Wipe the unit with a soft dry cloth only. If the unit is
very dirty, wipe it with a cloth soaked in warm water.
Cleaning the air filter
A clogged air filter reduces the cooling efficiency of
this unit. Please clean the filter once every 2 weeks.
1. Open the front panel by carefully lifting both ends at
the same time. At a certain angle, a clicking sound is
heard and it becomes self-supporting. For some models,
please use suspension bars to prop up the panel.
2. Use the tab provided to move the filter first up a little,
then slightly towards you. Now extract the filter by
gently drawing downwards.
3. Unclip the small air freshening filter from the large
air filter. Clean it with vacuum, and replace it
occasionally.
Filter Tab
8
CARE AND MAINTENANCE
9
Dimension drawing of indoor unit installation
Mounting plate
Wall-through Hole
Space to the ceiling
Space to the wall
Space to the floor
20cm left
20cm right
20cm above
Space to the wall
1. The wall for installation of the indoor unit shall
be hard and firm, so as to prevent vibration.
2. Use the “+” type screw to fasten the peg board;
horizontally mount the peg board on the wall, and
ensure the lateral horizontal and longitudinal vertical.
3. Pull the peg board by hand after the installation,
to confirm whether it is solid.
1. Make a hole with an electric hammer or a
water drill at the predetermined position on
the wall for piping, which shall slant outwardly
by 5
o
-10
o
.
2. To protect the piping and the cables from
being damaged running through the wall,
and from the rodents that may inhabit in
the hollow wall, a pipe protecting ring shall
be installed and sealed with putty.
Note: Usually, the wall hole is Φ60mm-Φ80mm.
Avoid pre-buried power wire and hard wall
when making the hole.
Putty
Pipe protection ring
Summary of Contents for Chrome
Page 8: ......
