Quick Guide
- 11 -
1.
Circuit board layout
Figure: DC-2964 F
2.
Installation
You will have to open your computer to install the DC-2964 F SCSI hostadapter.
Please note the relevant manufacturer's guarantee terms. Switch off and unplug the
computer before you ever open the casing! Plug the DC-2964 F SCSI hostadapter into
any free 32-bit "bus master" PCI slot.
3.
Connecting SCSI Devices
You can connect up to 7 different SCSI devices to the internal SCSI bus. Every
SCSI device is assigned its own SCSI-ID which is an address where commands
destined for the relevant device are to be sent to. Please make sure to set a different
ID for every connected device. The SCSI-ID for the DC-2964 F SCSI hostadapter is
set automatically by the hostadapter.
4.
SCSI Bus Termination
To ensure trouble-free signal transfer, both ends of the SCSI bus are to be
connected to so-called Termination Resistors. The SCSI hostadapter takes care of
termination automatically.
Please note that you have to disable the termination as you connect more than
one device, until only the last device at the SCSI bus has to be terminated. Always
check compliance with these conditions first if any functional defects occur.
Summary of Contents for DC-2964 F
Page 27: ...Br ve notice 27...
Page 28: ...Br ve notice 28...
