Installation Outline
Page 17
Procedure 4. Re-assemble the Radiation Shield
Refer to the disassembly drawings shown in Step 2 to re-assemble the Radiation
Shield.
1.
Make sure the Temp/Hum sensor cable runs through the cable channel
molded into the fan plate.
2.
Install the Junction Board Cover as shown in the illustration. The Junction
Board Cover should press easily into the place.
3.
Place the two radiation shield plates on top of the fan plate, open plate first
with the closed plate on top, being careful to line up the three screw holes.
4.
Gently place the mounting bracket on top of the radiation shield, being
careful to line up the three screw holes and also being very careful not to
move the top two (2) radiation shield plates.
Note:
Solar ISS: Place the mounting bracket with the solar panel positioned opposite
the location of the junction board.
5.
Hold the mounting bracket in place with one hand while you start the
three (3) long screws.
Tip:
Be sure to start all three screws before you tighten any of them.
6.
Place the rain collector base on top of the mounting bracket and fasten
using three screws. Do not over-tighten.
7.
Install the rain collector cone on the base, making sure that nothing inside
the cone interferes with the tipping bucket operation.
Procedure 5. Disconnect all Cables from the Old SIM.
Open up your old SIM housing and disconnect all cables from the SIM.
Junction Board
Cover
Junction
Board
Press in on Sides
near latches to
install or remove
cover.
Note:
ISS2 SPARS RetroKit D011.fm Page 17 Wednesday, April 23, 2003 11:26 AM
Summary of Contents for Vantage Pro ISS Retrofit Kit
Page 23: ...Troubleshooting Page 23...