DAVIS TMS-5500-SL, Manual

Page: 20 / 48

Rev Limiter:
(default (99 ) 9900 Rpm)
Once set the value will remain until changed by the
user. The RPM is set in 100 rpm increments,
(example 5000 rpm, divided by 100 = 50). To change
the Starting RPM value, follow these steps.
1. Set the “M” dial to “2”
2. Hold down the “Test” button
3. Turn the power On
4. While holding the “Test” button down, move
the dial to the first digit of the desired rev Limit
(must be greater than 5).
(example- 8300rpm - first digit=8 / 9500rpm - first digit =9)
5. Release the “Test” button,
The led will flash to show the value has been
accepted.
6. Now move the dial to the second digit of the
desired Rev Limit, then press and release the “Test”
button.
(example- 8300rpm - sec. digit=3 / 9500rpm - sec. digit =5)
The led will flash to show the value has been accepted.
After about 1 second the LED will Blink to show the value
that the Rev Limit is set to. The first digit is output
followed by a short pause, then the second digit is
output.
(8000 RPM = 8,0 Blinks) (zeros are indicated by
shorter blinks)
Note: The Rev Limiter can be tested at ½ of the set value
by setting the “T” dial to “0” and holding down the Test
button. (9000 RPM Rev Limit will cut engine at 4500
during test)
18
Davis Technologies TMS-5500-SL Elec Points
www.moretraction.com