12
CT Series Traction Control
www.moretraction.com
Main Menu
Sensitivity = 5
Max Retard = 16
Spread = 150
Corr Hold = 8
Sensitivity (
1-9
,
default=5
)
is used to adjust how
much tire slip will trigger a correction, the higher the
value the more sensitive, a good starting point is 4-
5.
Max Retard (
1-20*
,
default=15
)
sets the maximum
amount of retard that will be allowed with a full
correction. The unit will retard as much timing as
necessary to reduce or stop the slip up to the Max
Retard amount. If you never want the timing retarded
more than 18 degrees, then set the Max Retard to 18.
The retard is progressive throughout the Correction
Spread.
*max retard varies with different types of ignitions
Correction Spread (
0-500
,
default=150
) controls the
rate at which the system reaches the maximum
correction allowed. Once a slip is detected, if the RPM
reaches the top of the correction spread, then the
correction will reach maximum. The correction is
linear, so if the RPM spike only reaches 50% of the
spread, then only 50% of the max correction will be
allowed. If you lower the spread, then a full correction
will be achieved sooner. If SmartDrop® is enabled
(see below) then cylinders will be dropped if RPM
spike exceeds the maximum Correction Spread. If
spread is set to 150 and the spike is 150 or above,
then cylinders will begin to mis-fire, if SmartDrop® is
enabled.
Summary of Contents for CT Series
