4 of 10
19549P-83 (03-17)
Table 2: Alerts
“Connection Established”
“Connection Lost”
“Low Battery”
“Connection Deleted” (see
Purging
)
Triple Beep – Fringe Signal Area
“1,2,3 or 4” – Selection Indication (see
Operation
)
Operation
Power-up/power-down
To power up the U9110-BSW belt station, press and hold the POWER button for approximately
two seconds. The LED will turn red and then begin flashing orange. If the belt station has been
linked to a gateway and that gateway is in range, the belt station will automatically connect
within a few seconds.
To power down the U9110-BSW, press and hold the POWER button for approximately two
seconds. The LED will turn red and then turn off. The belt station is now powered down.
Auto Shut-off
Additionally, the belt station will automatically power down if it is disconnected from its gateway
for more than 30 minutes.
Headset
In order for the U9110-BSW to be used, a David Clark H9100-series headset must be connected.
To connect the headset, align red keyways and push. Pull back gently on the connector (behind
the quick-release collar) to ensure it is properly locked. To disconnect, pull back on the quick-
release collar.
There are separate left and right volume controls on the headset.
It is also important to properly wear the headset and correctly position the microphone. For
optimum noise-cancelling performance, position the microphone 1/8” to 1/4” (3-6 mm) from
your lips.
Summary of Contents for U9110-BSW
Page 2: ......
