19537P-26 (11-14)
5 of 15
1. Surface Mounting the M-RIM
Parts/Tools Required
q
Multiple-Radio Interface Module (41021G-01)
q
Pencil/Pen
q
Drill
q
3/16” Drill Bit
q
Drilling Template (
Figure 3
)
q
Philips-head screwdriver
q
Flat-head screwdriver
q
11/32-inch nut driver or wrench
Procedure
Location Considerations
Select a location on a flat surface that is out-of-the-way, and provides adequate room to attach all
cables. Be sure to allow for internal access, as adjustments may be necessary. The M-RIM is
weather resistant, however the mounting location should be chosen to minimize direct exposure
to the elements.
Mounting
q
Using a Philips screwdriver, remove the 4 screws on the cover of the M-RIM and lift off the
cover. Observe the 4 mounting holes in each corner, as shown in
Figure 2
.
q
Position the M-RIM Drilling Template and mark each hole with a pencil.
q
Confirm the location and carefully drill each hole using the drill and 3/16” bit.
q
Position the M-
RIM and insert a 3/16” machine screw into each mounting hole.
q
On the backside of the mounting wall, use the provided flat washer and lock nut to secure
the M-RIM (
Figure 2
).
