11
AquaReviva SPECIAL FEATURES
SYSTEM CONTROL (SANITISER OUTPUT DIAL)
7KH6\VWHP&RQWUROYDULHVWKHDPRXQWRIWLPHWKH&HOORSHUDWHVGXULQJWKH¿OWUDWLRQF\FOH
The System Control will not vary the electrical current supplied to the Cell.
$VDQH[DPSOHLIRQH¿OWUDWLRQF\FOHLVVHWDWKRXUVDQGWKH6\VWHP&RQWUROLVVHWWRWKHQWKHWRWDO
amount of time the Cell will operate during the 5-hour cycle will be 4 hours. If the System Control is set to
WKH&HOOZLOORSHUDWHIRUKRXUVWRWDORYHUWKHKRXU¿OWUDWLRQF\FOH$WWKH&HOOZLOOEH21IRUWKH
entire 5 hour cycle.
:KHQWKH6\VWHP&RQWUROLVVHWWRWKH&HOOZLOOEH2))IRUWKHGXUDWLRQRIWKH¿OWUDWLRQF\FOH:KHQWKH
6\VWHP&RQWUROLVVHWWRWKH&HOOZLOOEH21IRUWKHGXUDWLRQRIWKH¿OWUDWLRQF\FOH7RWXUQWKH&HOO2))
simply turn the System Control to 0.
NOTE: It is recommended to turn the sanitiser output dial to “0” when backwashing.
POLARITY INDICATORS A & B
These LEDs are used to check that the Cell current polarity is reversing. Whichever is on (or brightest)
indicates the polarity of operation. The Cell will operate in one polarity for a number of hours so any change
in these LEDs will happen slowly and depend on how the unit is operated.
LOW SALINITY INDICATION
<RXU$TXD5HYLYDLV¿WWHGZLWKDQXPEHURISURWHFWLYHV\VWHPVLQFOXGLQJWKHRSHUDWLRQ/('ZKRVHSULPDU\
function includes Low Salinity Indicator. As the TDS level in the pool decreases, the wear on the Cell
increases. Although Salt and Activator is not consumed in the sanitisation process, it is lost through
splashing, backwashing and on bathers as they leave the pool. The TDS level is also reduced by rain, which
causes dilution
As the TDS level in the pool falls toward the minimum TDS, the Operation LED will turn RED. At this point the
TDS level should be increased by adding the required amount of Salt as instructed by your pool water tester
or pool shop. The addition of Salt should not affect the AquaReviva power supply as it is protected against
overloads. If no action is taken and the TDS level continues to fall damage to the system may result.
There are other factors that can cause the Unit not to work correctly:
1. Heavy Rain
– can cause very diluted pool water to pass over the Cell due to surface skimming.
2. Scaled Cell
±DVFDOHG&HOOZLOOQRWGUDZDVPXFKHOHFWULFDOFXUUHQWDVDFOHDQ&HOOZKHQ¿UVWVWDUWHG
3. Cold Water
– cold pool water reduces the ability of a Cell to carry electrical current.
4. Failing Cell
– as the Cell ages there will come a time when the electrical current draw will drop. This can
be compensated for with the addition of extra Salt. A Cell is considered failed when it draws less than
RIPD[LPXPFXUUHQW3OHDVHQRWHWKDWWKH/RZ6DOLQLW\,QGLFDWRULVQRWOLNH7'6PHWHUVZKLFKDUH
WHPSHUDWXUHFRPSHQVDWHG6FLHQWL¿F,QVWUXPHQWV7KHDFFXUDF\ZLOOEHZLWKLQSSPDQGWKH\DUHZDWHU
temperature dependent, just as the Cell is.
403165_AquaReviva_I&OI.indd 11
4/7/17 9:18 am
