Dave Smith Instruments Prophet Rev2, User Manual

Page: 57 / 106

47 Prophet Rev2 User’s Guide Sequencer
Programming the Gated Sequencer
.
To program a gated sequence:
1. Press the
type
button and toggle to the gated sequencer.
2. Press the
mode
button and use the
value
knob to select the desired
mode. See “Sequencer Parameters” on page 48.
3. Use the
track
knob to select desired track.
4. Press the
destination
button and use the
value
knob to select the
desired destination.
5. Use the
parameter
knob to navigate to step 1 (or any desired step,
1-16).
6. Use the
value
knob to enter a value from 0-125. Choosing
reset
marks
the end of the sequence if you want to use fewer than 16 steps. The
sequence will loop when it reaches that step.
7. Repeat steps 5-6 as necessary to create the rest of the gated sequence.
8. When you’re done, hold down a key to listen to your sequence.
9. To save the sequence, save the program and they are saved together.
(See “Saving a Program” on “Saving a Program” on page 4.)
Try using different sequence lengths on different gated sequencer tracks to
create non-repetitive modulations. For example, if track 1 utilizes the full 16 steps, set
track 2 to repeat after 12 steps (by setting step 13 to
reset
).
Gated sequencer tracks are also modulation sources and appear as such
in the modulation matrix. This means that you can route a gated sequencer track to
multiple destinations.