Assembly and Installation Guide
33
4 Assembling instructions / Mounting the foot rods with step plate
Required hardware:
Foot rods (4f/4e) with welded bearing carrier and bearing retaining plate
Step plates (4g left and 4g-1 right) incl. mounting hardware from the
hardware kit and positioning stops (4h)
Required tool:
8mm and 13mm wrenches
4.1
The step plates (4g/4g-1) must be screwed in place first before the foot rods (4f/4e) right and left can be mounted. This
step plates are
not
identical! The difference is in the position of the
8 position holes
of the foot stopper (4H). The holes must
point to the front (see illustration below). The step plates must be properly identified before installation on the corresponding
right or left foot rod (4f/4e). Insert the flat head M5 screw (F) from above through the step plate (4g/4g-1) and the corresponding
holes in the foot rods (4f/4e) and secure (screw) it from underneath with the M5 nuts (H) and the appropriate washers (G).
You only have to pay attention that the side retaining wall on the step plates (4g/4g-1) is positioned on the proper side of the
foot rods (4f/4e). The retaining walls must be mounted towards the device body. They may not be positioned outwards.
Bearing retaining plate
4K
(welded)
Bearing retaining plate
4K
(welded)
GB
G / 4x
H / 4x
F / 4x
F
F
G
G
H
H
4g / 4g-1
4g-1
4e / 4f
4h
The 8 position holes of the foot stopper
(4h) must point to the front!
The 8 position holes of the foot
stopper (4h) must point to the front!
front
vorne
rear
Bearing carrier
4L
4e
foot rod / left side
Bearing carrier
rear
4L
Side view
Screw the step plate on the
foot rod
appropriate nut and
washer
side retaining wall
4g
Step plate position / left side
Flat head screw
M5 x 40
in the hardware bag
The side retaining wall must be placed
inside.
Step plate position / right
Top view
4f
foot rod / right side
Summary of Contents for ego_bike Premium 8
Page 1: ...User Manual ...
