Assembly and Installation Guide
32
3.4
Use the 13mm wrench to screw the two hinge pins (4c) in the threaded holes on the right and left sides of the dashboard
support column (3) and tighten them in place. The 13mm wrench adapts to the 13mm recess on the pin shaft.
3.5
Each of the oscillating poles (4/4a) is fitted with two bearing brackets. Mount the bearing bracket in the middle (4-2) on
the corresponding left and right hinge pin (4c) of the dashboard column (3) as shown in the drawing below. The curved
washer (K) supplied in the hardware kit must be fitted on the hinge pin (4c) before the pole. This washer then sits between
the welded bearing support (3-1) of the dashboard column (3) and the bearing bracket (4-2) of the oscillating pole.
3.6
Attach the oscillating poles (4/4a) to the hinge pins (4c) with the hexagon head screw (C) and the washer (D). At this
moment, the screw should be screwed loosely (not tight) using the supplied 13mm wrench (see 4.5 page 10 for the final
tightening of the screw).
3.7
Put the right/left protective caps (4d) on the M8 screw heads on the right and left sides after their final tightening (see
4.5 and 4.6 / page 33).
C
C
K
K
E
E
4a
4d
4d
3
1
4
13
3-1
3-1
4c
3
4-3
4-3
4-2
4-2
Summary of Contents for ego_bike Premium 8
Page 1: ...User Manual ...
