not at the end of the chain the load should be omitted.
2.4 INSTALLATION
To install the TFP into a computer chassis follow the steps below.
Remove the IACKIN*/IACKOUT* back plane jumper for the TFP slot. This step should be
performed even if TFP interrupts are not used.
bc635VME users must verify that signals on rows A and C of the P2 connector are not used
for VSB or other purposes. The TFP provides signal I/O on row A and C that may produce
a conflict. I f a conflict does exist, a solution is to obtain a bc635VME with the P2 connector
removed.
Verify that power is o ff and insert the TFP into the chassis, securing it in the slot by
tightening the two front panel screws.
2-4
bc635VME/bc350VXI Manual
D
a
t
u
m
Inc., Bancomm Div.
1