1 DATECS
LINEAPRO 7 INDUSTRIAL
USER MANUAL
UM 07.01.12/v1.0.0 17
Transferring data between Apple device and PC or MAC
LineaPro 7 Industrial is supporting sync function when USB cable is plugged.
Sync can be enable or disabled by setting. If
“pass
-
through sync”,
was disabled, when USB cable is
plugged to LineaPro 7 Industrial will be charge only.
To enter in sync mode can be used this way:
Holding scan button and plug the USB cable. After that scan button must be
release.
Turn off device function
When is pressed this turn off, LineaPro 7 Industrial is going to sleep mode immediately.
Charging Apple device
LineaPro 7 Industrial can charge Apple device, when power source (USB adapter) is attached to USB
connector or LineaPro 7 Industrial is placed on Datecs charging station. Charging current to Apple
device can be selected from application:
- 500mA (Default)
- 1000mA
LineaPro 7 Industrial can charge Apple device from his own battery. Only is need to be activated
function “Automated Charge”, to be start charging battery level of
LineaPro 7 Industrial must be
above 20%.
Updating Firmware
Firmware of LineaPro 7 Industrial
can be update with newer version. Press “Update Firmware” from
application, first will be shown current firmware version and to which version can be updated, then
press update.
Firmware of LineaPro 7 Industrial barcode engine can be update
with newer version. Press “Update
Barcode Engine Firmware” from application. First will be shown current firmware version and to
which version can be updated, then press update.
