DT1010 xx xx
20180403-V1
13
5.2. Connecting sensor / resistor / potentiometer to the
input
The following figure shows the wiring plan, connecting the
sensor / resistor / potentiometer to the input:
Wiring plan, connecting
the sensor / resistor /
potentiometer to the
input
(see also “Application
example”)
Checking the
Connections
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
