12
e.
Sleep Setting
This option sets the sleep time of the controller. The screen enters sleep
mode after the controller is idle for a pre-determined period.
1.
Move the joystick up / down the main menu and select “SLEEP
SETTING” by right moving the joystick or pressing
ENT
to enter “SLEEP
SETTING”.
2.
Move the joystick up / down the options list to select the desired idle
time before entering sleep mode by right moving the joystick or
pressing
ENT
to confirm.
f.
Pin Setting
This option sets the user and admin pins of the controller.
1.
Move the joystick up / down the main menu and select “PIN SETTING”
by right moving the joystick or pressing
ENT
. After entering “PIN
SETTING”, move the joystick up / down USER and ADMIN options and
select one by right moving the joystick or pressing
ENT
to confirm.
2.
After entering either USER or ADMIN, the user will be prompted to
enter the OLD PIN (Press ESC to cancel). If correct Pin is entered, the
user will be directed to “NEW PIN” menu. If incorrect pin is entered,
“ERROR” will be displayed.
3.
Input “NEW PIN”
4.
“CONFIRM”: after new pin is entered, enter the same pin again to
confirm. If the two pins do not match, “PIN NOT MATCH” will be
displayed and the menu will return to “NEW PIN” menu.
5.
If the two pins match, it will display “OK!” and the new pin will be
applied
To disable “PIN PROTECTION” function, there is no need to input any digit
in both “NEW PIN” boxes. Press ENT directly to confirm. To enable “PIN
PROTECTION” again, simply set new pins.
At any point, the user is allowed to press ESC key to exit the PIN setting
menu.
g.
Joystick Calibration
After the joystick is used for a long time, calibration may be required.
1.
Move the joystick up / down the main menu and select “JOYSTICK
CALIBRATION” by right moving the joystick or pressing ENT to confirm
2.
Once “JOYSTICK CALIBRATION” is entered, options list will be displayed;
the options are PAN Left / Right, TILT Up / Down, ZOOM Tele / Wide
and Free State. To calibrate “PAN LEFT”, move the joystick to its left
extreme and hold, and press ENT to complete “PAN LEFT” calibration.
3.
Refer to the “PAN LEFT” calibration to calibrate “PAN RIGHT”, “TILT
UP” and “TILT DOWN”.
4.
To calibrate “ZOOM TELE”, twist the joystick clockwise to the extreme
and press ENT
5.
To calibrate “ZOOM WIDE”, twist the joystick anticlockwise to the
extreme and press ENT
6.
“FREE STATE” calibration requires no action; the user can simply press
Summary of Contents for RMC-190
Page 1: ...0 ...
Page 16: ...15 8 Service Support ...
