Datavideo NVS-35, Instruction Manual

Page: 49 / 64

49
Input Button
Press the INPUT button to select between SDI and HDMI input sources. The button is
always in solid white.
The activated input source will be indicated by the LEDs above the button.

Green : Input source activated

Off : Input source deactivated
Note: The Input button is disabled while streaming or recording is in progress.
Record Button
Press the RECORD button to start/stop recording.
The table below summarizes the RECORD Button LED behaviors:
RECORD Button
Solid White Record function in idle state
Blinking Red Record function is activating or resetting
Solid Red Record function activated
Start recording

When idle, the RECORD button is solid white.

Press and hold the RECORD button for approximately 2 seconds.

When the record function is activating, the RECORD button turns from solid
white, then blinking red and finally to solid red.

When the RECORD button is solid red, this indicates that the record
function has been successfully activated.