Datavideo CCU-200, Instruction Manual

Page: 9 / 28

- 8 -
Power Supply
The CCU-200 accepts two power types, which
are AC IN and DC 48V IN. The AC IN is the main
power supply and the DC IN is the backup
power. When both sockets are connected of the
respective power sources, the AC IN will be the
primary source. The DC IN will start supplying
power only if the AC IN is disconnected.
Note: Connect the DC 48 IN to VMC-1*
(separate purchase).
RS-232/422 Port
The CCU-200 also allows you to connect and
control non-Datavideo cameras via RS-232/422
ports. See
Chapter 6 for cable pinouts.
DIP Switch
Use the DIP switch to switch
between RS-232 and RS-422. Bit
1 sets port 1, bit 2 sets port 2
and etc. Push up to enable RS-
232; push down to enable RS-
422.
Note: If you are using RS-232/RS-422 to control
the cameras, the corresponding AD-3s must
also be connected via RS-232/RS-422. See the
AD-3 Side Panel for details.
Rear Panel