- 8 -
Rear Panel
AUX Audio Output
2 channels of XLR Balanced Audio output.
AUX Audio Input
Mix input for background music or daisy chaining AM-100 units
together. To daisy chain units together, take the AUDIO OUT pair
from the first unit and connect these to the AUX IN on the second
unit. For more information, see
Example Cascade Setup
.
AUDIO IN
The AM-100 supports four XLR Balanced Audio Input channels.
There are two kinds of switches under
AUDIO IN:
LINE/MIC switch is used to set the audio as LINE in or MIC in. When
LINE in is selected please also set the
48V ON/OFF switch to OFF in
order to prevent burn-out damage to the circuit.
The
48V ON/OFF switch is for phantom power. If you want to use
MIC in, please set the
LINE/MIC switch first, and then if using a
Condenser microphone turn ON the
48V ON/OFF switch. If you
wish to use a Dynamic microphone please turn OFF the
48V
ON/OFF switch.
TALLY
TALLY IN socket. This supplies tally source, control output by A+V.
For more information please see the
A+V
.
DC IN – 4pin XLR
DC in socket connect the supplied 12V 2.5A PSU to this socket. The
connection can be secured by screwing the outer fastening ring of
the DC In plug to the socket.
Grounding Terminal
When connecting this unit to any other component, make sure that
it is properly grounded by connecting this terminal to an
appropriate point. When connecting, use the socket and be sure to
use wire with a cross-sectional area of at least 1.0 mm
2
.
