Page 8
4.0 - PROGRAMMABLE FEATURES
The alarm is factory preset with the following features enabled:
Factory settings
Feature
Acoustic signals
Panic alarm
State
Enabled
Enabled
!
!
Acoustic signals:
Panic alarm:
to confirm arming/disarming, alarm memory,
programming and learning of new devices.
for use in emergency situations. Panic alarms can be
triggered as many times as necessary, but at least 5 sec. must elapse
between 2 consecutive alarms. Pressing button 2 will immediately trigger
the siren and the turn indicators for approx. 30 seconds.
To turn OFF the panic alarm, press button 2 again.
5.0 - SLEEP MODE ACTIVATION/DEACTIVATION
If the vehicle will be sitting idle for long periods of time, the alarm can be
switched off (Sleep Mode) to preserve battery life.
To activate Sleep Mode, proceed as follows:
Turn ignition key ON; the LED will light up for approx. 1 second.
Touch the override key to its receptacle within 4 seconds.
ABeep will confirm the alarm has been turned off.
Turn ignition key OFF.
To restore normal operation, turn ignition key ON and then OFF.
!
!
!
!
!
Page 9
7.0 - REPLACING REMOTE CONTROL BATTERIES
Separate the shell
halves taking care
not to damage the
internal circuit.
Remove the
discharged batteries
and insert the new
ones taking care not to
invert the polarity.
Close the plastic
shells and make
sure the remote
works properly.
6.0 - USE AND MAINTENANCE
Care should be taken to protect the electronic alarm system:
Do not clean the alarm with water but use a damp cloth to wipe.
Do not expose the alarm to heat sources.
Do not use voltages other than the one specified by the manufacturer.
Protect the alarm from any direct water flow, such as a high-powered water
jet found in a car wash.
!
!
!
!
8.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
The present device falls within the field of application of the current WEEE
Directive. The crossed-out wheeled bin symbol on the equipment or on its
packaging indicates that the product, at the end of its useful life, must be
discarded separately from other waste to allow adequate treatment and
recycling.
The user must therefore take the equipment, at the end of its useful life, to an
appropriate waste collection facility.
If the batteries are running low the status LED will blink at the press of a button.
To replace the batteries proceed as follows:
WARNING
!
U
.
se only CR1616 batteries.
Different type batteries can seriously damage the remote control unit.
Discard used batteries properly in special dedicated containers
