Page 4
2.2 - Override touch key
The override key is a simplified remote control. In emergency situations
(remote control lost or inoperative), it can be used to arm/disarm the alarm or
trigger/stop the panic alarm (selectable feature, factory enabled).
To use the override key, simply touch it to its receptacle. The receptacle
incorporates a LED warning light that serves as both a system status indicator
and a visual theft deterrent.
2.0 - ALARM CONTROL DEVICES
The 2-button remote control and the override touch key are used to operate the
alarm system.
Page 5
3.0 - ALARM OPERATION
3.1 - Arming
Press remote control button 1 or touch the override key to its receptacle to arm
the alarm. Arming is confirmed by a long flash of the turn indicators and 2 short
Beeps. The LED turns ON steady.
3.2
-
Passive
I
mmobilisation
Passive engine immobiliser arms automatically 40 sec. after ignition is turned
OFF. Lifting the seat or opening the topcase (if protected by a contact switch)
during the 40 sec. arming delay will cause the procedure to interrupt; it will
resume once the seat or the topcase are closed. Passive arming is confirmed by
2 Beeps and 2 flashes of the turn indicators and the LED will start flashing quickly.
To disarm passive engine immobiliser, turn ignition ON and press any
remote control button.
3.3
-
Topcase/Seat
open
warning
signal
If, during the arming process, the seat or topcase are open or incorrectly closed,
a BOP will sound after the arming confirmation tones.
The alarm will arm but an alarm condition will be triggered after the arming delay.
3.4
-
Arming
delay
There is a 20 sec. activation delay from the time the system is armed. During the
arming delay the LED is ON steady it will start flashing as soon as the system will
be fully armed. Engine immobilisation and optional module inputs are
immediately enabled.
3.5
-
Siren
exclusion
(mute
alarm)
During the first 4 seconds of the arming delay, the siren can be excluded by
pressing remote control button 2. The turn indicators will flash to confirm the
siren has been excluded.
NOTE
If the siren is excluded only the turn indicators will flash during an alarm event.
Engine immobilisation remains enabled.
NB:
Siren exclusion is bound to each single arming cycle.
Override key
Override key
2.1 - Remote control
The remote control has 2 different function buttons each of which corresponds
to a control signal that activates a selected action according to the operational
condition and alarm configuration.
The textured button is for arming/disarming the alarm while the smooth button
is used to exclude or trigger the siren.
The remote control has a low charge battery indicator that gives you early
warning to avoid malfunctioning. When the batteries are fully charged, the LED
will show a steady light at the press of a button. If the batteries are too weak for
normal operation, the LED will start blinking at the press of a button.
Button 1
LED
indicator
Button 2
Button 1
Button
:
2:
• Arm/disarm alarm unit
• Trigger/Stop p
alarm
• Exclude siren (mute alarm)
anic
• Activate Hazard lights
