SCS1
Series
Instruction
Manual
98
Parameters
The
X, Y, angle and reference system
parameters refer to the central
Edge locator
.
Length, thickness, variation type, direction, thresholds and constraints
are relative to all the
locators that form the inclinometer.
X:
coordinate that identifies the horizontal position of the first locator point.
Y:
coordinate that identifies the vertical position of the first locator point.
Length:
ROI length.
Thickness:
elaboration area thickness.
Angle:
expressed in degrees, calculated according to the tool rotation respect to the X axis.
Variation type:
-
“from white to black”: only negative edges are considered;
-
“from black to white”: only positive edges are considered;
-
“both”: both edges are considered;
-
“automatic”: tool selects automatically which variation to distinguish.
Direction:
determines the direction of the elaboration:
-
“from start to end”: elaboration starts from the first end and continues towards the arrow;
-
“from end to start”: elaboration starts from the arrow and continues towards the first end
(opposite to the arrow’s direction).
Points:
this parameter specifies the number of edge points the tool tracks and will be used to obtain
the interpolated segment. Consequently the parameter establishes the number of
Edge locators
used. If the number is even, the reference
Edge locator
is not considered, while it is considered if
the result is an odd number. Half of
Edge locators
are positioned on the left side of the reference
Edge locator
located and the other half on the right side. The distance between the locators is equal
to half of the thickness of each.
Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - e.mail: [email protected]
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
