Operation Manual, RA2400 & RA7300 Power Amplifiers
Page 17
Document # 9301H62800 Ver. 1.00
Automatic (Trigger) On
First, make certain that the connection from the RA2400/RA7300 to the controlling device is
correct.
Turn on the controlling device and verify that the RA2400/RA7300 is automatically activated after a
short pause. Remember, this pause is intentional and is used to protect your speakers from
damage while the amplifier stabilizes. You may also hear a slight relay click during start up and this
is also normal.
Next, verify your RA2400/RA7300 automatically turns off when the controlling device is powered
off. Once the controlling device is powered off, the RA2400/RA7300 should automatically turn off
after a few moments.
AC LINE CONNECTOR AND POWER CORD(s)
Your RA2400/RA7300 is supplied with an internationally approved (IEC) power line connector that
accepts the supplied detachable, high-current capacity power cord(s). The RA7300 has two power
cords and the RA2400 comes with one.
WARNING: UNDER NO CIRCUMSTANCES SHOULD THE ROUND
THIRD PRONG BE CUT, BENT OR IN ANY OTHER WAY DEFEATED AS
THIS MAY RESULT IN SEVERE SHOCK.
Main Circuit Breaker
Your RA2400/RA7300 is supplied with one or two heavy-duty magnetic circuit breaker(s).
●
If power to your RA2400/RA7300 is interrupted, inspect the circuit breaker on the rear of the
unit.
●
If the circuit breaker is in the off position you may reset it to the on position to restore AC power.
●
If the circuit breaker immediately trips to the off position, unplug the RA2400/RA7300 from the
AC power source and contact the Datasat Technical Support, email
or (if
you are located in or close to Europe)
.
WARNING: ALWAYS TURN OFF THE RA2400/RA7300 AND UNPLUG THE POWER CORD(S)
BEFORE MAKING ANY ELECTRICAL CONNECTIONS.
