Operation Manual, RA2400 & RA7300 Power Amplifiers
Page 12
Document # 9301H62800 Ver. 1.00
Dip Switch
Example:
In a typical 7.1 set up using a separate self-powered sub you would assign
the dip switches as follows:
In the example, the settings allow Input 4, channel four (the subwoofer channel from the RS20i),
to bypass the “Balanced Analog Audio In 1-8” DB25 connector so that the subwoofer signal can
connect to an external subwoofer amplifier via the “Analog Audio pass-thru 1-8” DB25 connector.
Note that the pass-thru connector outputs are not affected by the dip switch settings; in other
words, the DB25 channel inputs are passed directly to the pass-thru DB25 connector below.
PLEASE CONSULT WITH DATASAT OR YOUR INSTALLER/DEALER IF THERE IS ANY
DOUBT.
DB25 Audio In select switches:
DB25 Input 1 ON = RA Channel A
DB25 Input 2 ON = RA Channel B
DB25 Input 3 ON = RA Channel C
DB25 Input 4 OFF
DB25 Input 5 ON = RA Channel D
DB25 Input 6 ON = RA Channel E
DB25 Input 7 ON = RA Channel F
DB25 Input 8 ON = RA Channel G
Notes:
RA = RA2400/RA7300
Input 4 = subwoofer channel from RS20i
“Input” on RA = “channel” output on RS20i
From RS20i
RA2400
