V130108E
iBoot-G2+
Page 28
Autoping Commands
These commands require a reboot before they will take effect.
These commands are available to the administrator only.
get autoping
This command returns all of the AutoPing settings as shown below.
Autoping
1
A
B
Status
Trigger
Count
IP
Address:
123.12.123.12
0.0.0.0
OK
0
Frequency:
1
10
Fail
Count:
1
3
Logic:
A
And
B
Action:
None
Cycle:
1
Outlet:
Main
Wait:
2
Autoping
2
Status
Trigger
Count
IP
Address:
0.0.0.0
OK
0
Frequency:
10
Fail
Count:
3
Action:
None
Cycle:
1
Outlet:
Exp1
Wait:
2
Autoping
3
Status
Trigger
Count
IP
Address:
0.0.0.0
OK
0
Frequency:
10
Fail
Count:
3
Action:
None
Cycle:
1
Outlet:
Exp2
Wait:
2
set autoping <1a | 1b | 2 | 3> ipaddress
<dotted decimal>
This command is used to set the IP address of
AutoPing 1 or AutoPing 2
0.0.0.0
set autoping <1a | 1b | 2 | 3> frequency
<1-999>
This command is used to set the frequency, in
seconds (how often the iBoot-G2+ sends the ping) for
each of the AutoPings.
10
set autoping <1a | 1b | 2 | 3> failcount <1-
999>
This command is used to set the number of
consecutive failures the AutoPings must detect before
the AutoPing considers the pinged device to be failed.
3
set autoping 1 logic <a | and | or>
Sets logic for AutoPing 1. A = A Only, and = A and B,
or = A or B.
A and B
Set autoping <1 | 2 | 3> outlet <main |
exp1 | exp2>
This command sets the outlet that the AutoPing will
trigger.
Main
set autoping <1 | 2 | 3> action <none | on-
latch | on-follow | off-latch | off-follow |
cycle>
This command is used to set the action that the iBoot-
G2+ will perform when the AutoPing triggers.
None
set autoping <1 | 2 | 3> cycle <0-999>
This command sets the maximum number of power
cycles when the AutoPing triggers. 0 = Unlimited
1
set autoping <1 | 2 | 3> wait <1-999>
This command sets the time, in seconds for the device
to respond to a ping.
2
