V130108E
iBoot-G2+
Page 15
iBoot Expansion Units
Select Link to Main to have the status of the
Expansion unit be identical to the Main outlet of
iBoot-G2+ . This is convenient if switching both
power supplies of dual redundant powered devices.
Power Control
Each of the two inputs is independently set. Select the target outlet, main, Exp1 or Exp2 and the action
desired with the input is Closed. The choices for action are:
On
Turn the power Of
Off
Turn the power Off
Cycle
Change the power for the Cycle Time setting
Toggle Change the state of the power. From Off to On
or On to Off, depending on current state.
The power is controlled when the input is connected to ground. When set for On or Off, holding the input to
ground will lock the power in the selected position allowing for manual override of all other control options. By
using both inputs, one set for On and the other for Off, you can use a three position switch to create an On –
Remote – Off switch.
Independent I/O:
Check Remote Control Enable to allow external
devices to control via DxP protocol. Leave unchecked
to prevent unwanted control via DxP. To allow the
inputs of Exp1 and Exp2 to control additional devices
via DxP Protocol, enter the IP address and relay
number of the device to be controlled.
Input Connections to Switches for
Power Control
