Datalogic Touch 90 pro, Product Reference Manual

Page: 250 / 332

Enter/Exit Programming Mode BC412
240 Touch TD1100
BC412 Length Control
This feature specifies either variable length decoding or fixed length decoding for the BC412
symbology.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
BC412 Set Length 1
This feature specifies one of the bar code lengths for BC412 Length Control . Length 1 is the
minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length
Mode. Length includes the bar code’s data characters only.
The length can be set from 0 to 50 characters. See "Set Length 1" on page 278 for more detailed
programming instructions.
$CBCLC00 
BC412 Length Control = Variable Length
$CBCLC01 
BC412 Length Control = Fixed Length
DEFAULT
$CBCL1
Select BC412 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
01 = Length 1 is 1 Character