Datalogic QuickScan I QD21 1 Series, Product Reference Manual

Page: 20 / 360

10 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Connecting the Base when Security Pin is Enabled
When connecting the Base to a system that has a custom Security Pin enabled,
follow the steps below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface cable into the Base
as shown .
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base
5. When the host completely powers up, a new custom Security Pin Code may
be sent to the reader and Base, depending on host configuration. Contact
Datalogic Technical Support for more information.
Linking the Reader to a Base Station
RF Devices
For RF devices, before configuring the interface it is necessary to link the hand-
held with the base. To link the handheld and the base, press the trigger to wake
it and place it on the base. If the reader was previously linked to another base,
you must first scan the Unlink action command before re-linking to the new
base.
Unlink
BT Models only
Remember: The mandatory condition for establishing a new linking between a
BT handheld and a BT base is that the handheld is unlinked and they share the
same security configuration. A successful link is indicated by three ascending
tones from the reader. A high-low-high-low tone indicates the link attempt
was unsuccessful. A single green LED flash after this tone indicates no Base
Station was discovered. Two green LED flashes after this tone indicates that
more than one Base Station was discovered and the reader did not link. Three
LED flashes after this tone indicate a security error.
NOTE
If you want to change security settings or set up a PIN, see
"BT Security Mode"
on
page 269.