Enter/Exit Programming Mode
Product Reference Guide
223
PBT950X-ONLY FEATURES
The features in this section are valid only for PBT950X Bluetooth models.
Also reference the Setup section for instructions on
BLUETOOTH SECURITY FEATURES
On the Bluetooth system, it is possible to set a (configurable) PIN code to
authenticate/connect Bluetooth devices, and encrypt the data.
The Bluetooth PIN code can be enabled and configured by reading the bar
codes in the following sections.
If you are using a Bluetooth scanner directly connected to a host through a
Bluetooth dongle, verify that the scanner and the Bluetooth driver used by
the dongle share the same PIN code and the same security level. Otherwise
the connection cannot be established.
Follow these steps to set the PIN code for a scanner:
1.
Bluetooth Security Mode by scanning the “Enable” bar code
below.
2.
Select a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in
3. Scan the relevant bar code from
on page 225, then scan
the desired alphanumeric characters from the keypad in
to set the PIN code.
in
“References” for more detailed information and examples
for this feature.
Summary of Contents for PowerScan 950X Series
