Datalogic OM-GRYPHON SERIES, Quick Reference

Page: 19 / 76

English
13
OM-GRYPHON DEFAULT CONFIGURATION
RS232 DEFAULT SETTINGS
9600 baud, parity disabled, 8 data bits, 1 stop bit, handshaking disabled,
delay disabled, 5 sec. rx timeout
PEN DEFAULT SETTINGS
output level normal, idle level normal, minimum output pulse 600
µ
s, overflow
medium
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, num lock off, delays disabled
CRADLE OPERATING PARAMETERS
No header, terminator: RS232 = CR-LF; WEDGE = ENTER
INFORMATION FOR THE USER
DC supply voltage in the range 9 to 28 V DC, intended to be powered by a
Class 2 power unit with a cable length <3 m.
This device must be opened by qualified personnel only.
Modifications or changes to this equipment without the expressed written
approval of Datalogic could void the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Contact the competent authority responsible for the management of radio
frequency devices of your country to verify the eventual necessity of a user
license.
Refer to the web site
http://europa.eu.int/comm/enterprise/rtte/spectr.htm for
further information.