3-1
Datalogic Automation, Inc..
C H A P T E R 3
MX-U Series Cameras
Introduction
This section describes digital cameras provided by Datalogic Automation, Inc. Our USB cameras can be used only with
our MX-U Series Processors. GigE cameras will not operate on a MX-U Series Processor.
Datalogic Automation, Inc. does not support the use of these cameras in any manner other than described herein.
MX-U Series cameras acquire an image when a signal is present on the trigger input of the camera trigger cable, then dig-
itize images at the camera source and transmit them directly to the processor over the USB cable. These cameras provide
8-bit resolution using internal 12-bit A/D converters and some have progressive scan shutter exposure (allowing individ-
ual pixel readings).
The total processor-to-camera bandwidth is 600 Megapixels per second. Each connected camera shares this bandwidth.
For example, if two cameras are connected, each camera can use up to a maximum of 300 Megapixels per second. For
four cameras, each camera can use up to a maximum of 150 Megapixels per second. This means that both the camera res-
olution and the number of connected cameras can affect the frames per second (fps) value for all connected cameras.
MX-U Series cameras have a hard-coat finish case that helps eliminate ground loops. All camera settings (shutter, strobe,
partial scan, etc.) are configured using Impact software and are maintained in the MX-U Series processors’ memory so
there are no physical switches on the cameras.
All camera settings must be configured using the Settings tab in the Vision Program Manager (VPM) or in the Settings
program. For more detailed information, refer to the Impact Reference Guide (843-0093).
Safety Precautions
Read all of the following instructions before setting up your camera. Save this document for later use.
•
Follow all warnings and instructions in this manual and in other user guides shipped with your hardware components.
•
Do not attempt to disassemble the camera. Do not remove screws or attachments. There are no user-serviceable parts
inside. Refer servicing to Datalogic Automation, Inc.
•
All MX-U Series cameras connect power and image transmission to the MX-U Series Processors using a USB cable
from Datalogic. Using any other cable may cause intermittent data transmission. Cameras connect to triggering signals
and strobe output using a cable and terminal block. See “Connecting the Camera” on page 3-5 for more details.
•
This camera is designed for indoor use. Do not expose it to moisture, including rain or snow, and avoid operating it in
wet areas. Should the camera become wet, turn off the power immediately. Moisture can damage the camera and create
danger of electric shock. Avoid using the camera when the humidity is above 80%.
•
Make sure your camera has enough airflow around it for proper ventilation. The safe case temperature during operation
is from 0° to 50° C (32° to 122° F).
Summary of Contents for MX-U100
